This device complies with Industry Canada licence-exempt RSS standard(s). NĜonsult the dealer or an experienced radio/TV technician. NĜonnect the equipment to an outlet on a circuit different from which the receiver is connected. N Increase separation between the equipment and receiver. N Reorient or relocate the receiving antenna. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures: However, there is no guarantee that interference will not occur. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. This device must accept any interference received, including interference that may cause undesired operation. This device may not cause harmful interference, andĢ. Operation is subject to the following two conditions:ġ. Reconfigure the Cisco Wireless Controller so that it is not the master.Also, if the access point is not on the same subnet as the Cisco Wireless Controller, be sure that there is a properly configured DHCP server on the same subnet as the access point. Check the connection between the access point and the Cisco Wireless Controller, and be sure the access point and the Cisco Wireless Controller are either on the same subnet or that the access point has a route back to its primary, secondary, and tertiary Cisco Wireless Controller. If the LED blinks sequentially for more than 5 minutes, the access point is unable to find its primary, secondary, and tertiary Cisco Wireless Controller.If the LED is not on, the access point is most likely not receiving power.When the access point has joined a controller, the LED is chirping green if no clients are associated or green if one or more clients are associated. During this process, the LED blinks sequentially green, red, and off. If the power-up sequence is successful, the discovery and join process begins. When you power up the access point, it begins a power-up sequence that you can verify by observing the access point LED.Observe the access point LED (for LED descriptions, see Checking the Access Point LEDs.Patch Antenna, 4-port, with N connectors. Wall Mount Omni Self-Identifying Antenna, 4-port, with RP-TNC connectors.Ħ0° Patch Antenna, 4-port, with RP-TNC connectors.Ħ0° Patch Self-Identifying Antenna, 4-port, with RP-TNC connectors.Ħ0° Patch Self-Identifying Antenna, 4-port, with 4DART connector.ĭirectional Self-Identifying Antenna, 4-port, with 4DART connector.ĭirectional Antenna, 4-port, with RP-TNC connectors.ĭirectional Self-Identifying Antenna, 4-port, with RP-TNC connectors. Wall Mount Omni Antenna, 4-port, with RP-TNC connectors. Low Profile Self-Identifying Antenna, White, with RP-TNC connectors. Low Profile Antenna, White, with RP-TNC connectors. List of External Antennas Supported on C9120AXE and C9120AXPĭipole Antenna, Black, with RP-TNC connectors.ĭipole Antenna, Gray, with RP-TNC connectors.ĭipole Antenna, White, with RP-TNC connectors.ĭipole Self-Identifying Antenna, White, with RP-TNC connectors.Ĭeiling Mount Omni Antenna, 4-port, with RP-TNC connectors.Ĭeiling Mount Omni Self-Identifying Antenna, 4-port, with RP-TNC connectors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |